User manual

NOTE : PRESS
EFAULT IS “001” FOR
GGGGGGGGGG
PRESS
TO ACCESS THE MENU
NOTE : THE CAMERA ID IS A
DIGIT NUMBER.
REMOTE CONTROL
*
1. Set the Camera iD in the OSD menu. The default
setting is 001. NOTE :
you must reset the power for the new settings to
apply. Once you reset the power, the camera will
recognize the new Camera ID.
2. If you press the KEY Button, the camera display
will turn into the standby image. NOTE : The LED
3. Input the same number used as the Camera ID to
the Remote Controller. After the number has been
input, the LED light will turn on, and the remote
controller will be ready to use. NOTE : The ID
number is 3 digits.
4. The ZOOM In (+) and ZOOM Out (-) Keys are used
to control the zoom of your camera lens and to
select the zoom area of alarm function. Select the
area where you wish to observe the movement of
objects.
5. Select the zoom range by pressing the WIDE (7)
Key. Save the zoom range by pressing the TELE (8)
Key. NOTE: If
the zoom range is smaller than the
alarm standby range, the zoom range setting will
not be saved.
Menu Access and Control
Motion Alarm
ON / OFF
Key Button
ID Buttons
Zoom Function Control
̰G
REMOTE CONTROL Instructions
9