User manual

EXPOSURE
BRIGHTNESS 0 ~ 99
E.SHUTTER 1/60, 1/100FLC, 1/120~1/100000
BLC
OFF / ON
BLC (Back Light Compensation)
AGC
HIGH / MIDDLE / LOW / OFF
AGC(Auto Gain Control)
MAX_DR OFF / ON (0~20) (Electronic Wide Dynamic Range)
STARLIGHT AUTO (x2 ~ x256) / OFF (x32 is recommended for low light application.)
EXIT JUMP EXIT / SAVE & EXIT / FACTORY SET
COLOR
WB MODE AWC / ATW / MANUAL / PUSHLOCK
R-Y GAIN 0 ~ 255
B-Y GAIN 0 ~ 255
EXIT JUMP EXIT / SAVE & EXIT / FACTORY SET
DAY & NIGHT
D & N Mode
AUTO / COLOR / BW
COLOR---->BW : Switching from COLOR to BW; If the number is higher, the camera will only
switch during a super low light condition.
BW ---->COLOR : Switching from BW to COLOR; This number should be always lower than
COLOR to BW
Read Time : time interval to switch from COLOR to BW
COLOR
B&W Mode : (BURST : OFF/ON) When the burst is OFF, the picture will have less noise.
C-SUP
Color Suppression : Color will be reduced at low illumination, if the C_SUP Level is higher.
0 ~ 100 (not available when 3D-DNR is on)
A-SUP
Aperture Suppression : Edge sharpness will be reduced at low illumination, if A_SUP Level
is higher. 0 ~ 100 (not available when 3D-DNR is on)
EXIT JUMP EXIT / SAVE & EXIT / FACTORY SET
FUNCTION
MIRROR OFF/MIRROR/V-FLIP/ROTATE
SHARPNESS 0 ~ 49
GAMMA 0.45 ~ 1.00 / USER
FREEZE OFF / ON
NEGA. OFF/ ON
3D-DNR
OFF / LOW / MIDDLE / HIGH
3D DNR (3D Digital Noise Reduction)
D-ZOOM OFF / ON(x1.0 ~ x3.0 Digital PTZ)
SLC
OFF / ON
SLC (Side Light Compensation)
HME
OFF / ON
HME (Highlight Masking Exposure)
DIS OFF /ON
DIS (Digital Image Stabilizer)
EXIT JUMP EXIT / SAVE&EXIT / FACTORY SET
MOTION
MOTION
OFF / ON
SET WINDOW
ALL SET (Set the Entire Screen)
ALL CLEAR (Clear the Entire Screen)
SENSITI.(1~120)
SHOW INDI.(OFF / ICON / TRACE)
DELAY OUT (1 ~ 15)
Motion Alarm Zoom-In Delay
EXIT JUMP EXIT / SAVE&EXIT / FACTORY SET
OSD MENU
*
-V3367WD, V3367WTIR
2120