Quick Start Guide

1. Once all cables have been connected, use the screws included with the camera to properly mount and secure the camera to

the mounting surface.

2. Adjust the camera’s pan, tilt and position to achieve the desired view. To adjust the camera’s angle, loosen the pan/tilt/rotation

screw at the base of the camera. . The cameras’ max angles are:

Pan: 0° ~ 360°

Tilt: 0° ~ 90°

Rotation: 0° ~ 360°

3. The DWC-VA583WTIR camera includes a vari-focal p-iris lens with motorized zoom and auto-focus. The zoom and focus can

be controlled using the up the coax (UTC) communications. Simply connect the camera to a UTC enabled DVR and adjust the

camera’s zoom and focus remotely from the DVR.

4. Once the installation is complete, tighten the pan/tilt/rotation screw until it’s secure.

Quick Start Guide

1. The camera supports HD-Analog, HD-CVI and HD-TVI signals. To

switch between the signals:

a. Enter the camera’s OSD menu. You can access it locally from

using the camera’s joystick in the body of the camera, or from a

recorder supporting UTC communication. Go to SETUP >

OUTPUT > ANALOG MODE.

b. Set the camera’s analog signal output from the following options:

• HD-A: supports 5MP/1944p @ 20fps and 12.5fps, 4MP/1440p @

30fps, 2.1MP/1080p @ 30fps and 720p @ 30fps.

• HD-T: supports 5MP/1944p @ 20fps, 4MP/1440p @ 30fps,

2.1MP/1080p @ 30fps and 720p @ 30fps.

• HD-C: supports 4MP/1440p @ 30fps, 2.1MP/1080p @ 30fps and

720p @ 30fps.

• CVBS: supports up to 960H @ 30fps

c. Change CONFIRM to ON to save the changes.

d. Go to the EXIT menu and select SAVE&EXIT to save all changes.

The camera signal automatically.

STEP 4 – INSTALLING THE CAMERASTEP 3 – CHANGING THE SIGNAL IN

THE CAMERA

Rev Date: 06/19

Speciﬁcations and pricing are subject to change without notice.

Rotation 360°

Titling 90°

Panning 360°