User's Manual

DWC-T8553TIR, DWC-T8563TIR
6
4 INSTALLATION
1. The mounting surface must withstand
three times the weight of your camera.
2. Do not let the cables get caught in
improper places for the electric line
cover can be damaged. This may
cause a short or fire.
3. Using the mounting template, sheet or
the camera itself, mark and drill the
necessary holes in the wall or ceiling.
4. Do not remove the protective film until
the installation I completed.
5. Pass wires through the mounting
bracket and make all necessary
connections. Connect the BNC and
power cables to the camera. Connect
the camera to a DVR or encoder.
6. The cameras support three analog
signals: HD-Analog, HD-TVI and HD-
CVI. See section 5 for more
information on how to change the
signal.
7. Mount the rubber plug to the gap of the mounting base.
8. Adjust the camera to obtain an optimum angle by loosening the lock screws.
Tighten the lock screws after you finish adjusting the view angle of the camera
(see section 7).
9. If your camera supports a varifocal lens (DWC-T8563TIR models), adjust the
zoom and focus as needed (see section 7).
10. Remove the protection file softly to finish the installation.