User Guide
Quick Start Guide
Copyright © Digital Watchdog. All rights reserved.
Specifications and pricing are subject to change without notice.
INSTALLATION
1
Secure the hanging mount to the pole (NTP ¾ thread).
2
Before attaching the camera to the hanging mount, remove the dome from
the camera base.
3
Ax the safety wire at the bottom of the hanging mount. Connect the
other side of the safety wire to the base of the camera.
4
Pass wires through and make all necessary connections.
5
Use the camera mounting screws (included with bracket) to secure the
camera to the mount cap. Align the indented lines on the side of the
camera with the lines on the hanging mount. Rotate the camera clockwise
to lock into position.
UNLOCK
LOCK
6
Adjust the camera lens modules’ position and complete the
installation by placing the dome cover on the camera. See the
camera’s QSG for camera setup information.
NOTE: Do not touch the lenses when handling the camera modules.
Rev: 10/22
Camera base
NTP 3/4 TAP
Pipe
Mount Cap