User Manual

1
Network Type -DefinenetworkIPaddresstypefromtheStaticModeforthefixedIPortheDynamicModebythedynamic
IP address.
IfyouselecttheStaticMode,youmustfilloutIPAddress,SubnetMask,Gateway,DNSServerandallports.
If you select the Dynamic Mode, the IP address will be allocated automatically by DHCP equipment.
If you click the Apply button to update changes, the system will be re-booted.
In this case, you have to reconnect the camera using new IP address.
2
IP Address -DefinetheIPaddress.Theaddressisconsistedoffournumbersseparatedbydotsandtherangeofeachnumberis
from 0 to 255.
3
Subnet Mask -DefinetheSubnetMask.FormatissameastheIPaddress.
4
Default Gateway - Default the Gateway IP Address. Format is same as the IP address.
5
Preferred DNS Server -DefinetheDNSserverIPaddress.FormatissameastheIPaddress.
6
Alternate DNS Server -DefinetheSecondaryDNSserverIPaddress.FormatissameastheIPaddress.
7
HTTP Port - The HTTP port can be set to 80 which default or in between 1025 to 60000.
8
HTTPS Port - The HTTPS port can be set to 443 which default or in between1025 to 60000.
9
RTSP Port - The RTSP port can be set to 554 which default or in between 1025 to 60000.
10
Click‘Apply’tomakeabovesettingeffective.
If the network type is dynamic, the IP address is changed in below cases.
Therefore, the IP address needs to be searched again, and the camera needs to be reconnected in these cases.
- Whenthecamerapowerison/off.
- After Firmware update, Default set and reboot.
Setup - Network Setup
Network Settings
1
2
3
4
7
5
8
6
9
10
39