User Manual

Network Setup -
Port Forwarding
After entering the correct TCP/IP settings,
you are ready for ‘Port Forwarding’
(Cases A, B).
1
Please record the TCP/IP settings of your IP Camera for
future reference. You may need this information to access
yourIPCameraandtoconfigure‘PortForwarding’.
2
After clicking ‘Apply’, the system will prompt for reboot.
Please allow the system 50 seconds to reboot and accept
thechanges.After50seconds,closetheconfiguration 
screen.
The view will display ‘Trying to Reconnect’. If the ACTIVE
lightontheIPCamerahasgoneoffandisnowbackon 
againflashing,theIPCamerahasrebooted.Afterthe 
system reboots completely, remove the power supply from
the unit and close Internet Explorer.
3
Return your PC/Laptop TCP/IP properties to their original
settings.
4
Before installing the IP Camera, you must use
‘Port Forwarding’ on your personal router (Cases A, B).
You will need to forward 1 ports:
· Web Port
All the ports will be forwarded to the IP address you
assigned to the IP Camera.
In the example above, you would forward:
· 8888 > 192.168.0.200
i
For information on how to use ‘Port Forwarding’,
please read Appendix C.
IP Address
Subnet Mask
Default Gateway
Preferred DNS Server
DDNS Server
Web Port
IP Camera TCP/IP Settings
19