Instruction Manual

41
For use with administrative computers (managers) to monitor devices on a computer network, Simple Network
Management Protocol (SNMP) settings can be applied to the camera.
1
SNMPv1/SNMPv2 - Select the SNMPv1/SNMPv2 option and type the names of Read and Write communities.
SNMP trap can be used to check periodically for operational thresholds or failures that are defined in the MIB.
2
SNMP Trap - Enable or disable the SNMP trap.
SNMPv3 contains cryptographic security, a higher security level, which allows you to set the Authentication
password and the Encryption password.
3
Mode - Select either Read or Read/Write mode.
4
Activation - Select mode to enable or disable.
5
Read/Write name - Define Read name and Write name.
6
Security Level - Select one of no auth, no priv/auth, priv.
7
Authentication Algorithm - Select MD5 or SHA as the authentication method.
8
Authentication Password - The Authentication Password is encryption for authentication and is between 8
to 30 digits long.
9
Private-Key Algorithm - Select DES or AES as the encryption algorithm.
10
Private-Key Password - The information protection password is a private encryption at least 8 digits and up to
30 digits long.
11
Click ‘Apply’ to save all settings.
Setup - Network Setup
SNMP Settings
4
5
3
6
7
8
9
10
11
2
1