Manual

8
Installation -
Adjusting the Camera's Pan and Tilt
6 Pull wires through and make all necessary
connections. See 'Cabling' section for more
information.
7 Connect the camera's main body to the mounting
bracket.
8 Adjust the panning angle of the camera and tighten
hard lock set screw to fix the camera. Use the
included six-angle wrench included with the camera
to tighten the screw and secure the camera module
to the mounting bracket.
9 Adjust the lens' angle by adjusting the controlling
screws on the main body. Use the included T-
wrench. The screws located at the base of the
camera dome control the lens' tilt up and down and
its rotation.
Lens Tilt
Lens Rotation
10
When the installation is complete, detach the
protective film from the camera’s dome.
Warning:
The camera's lens module can rotate 360¡ at each
direction. Rotating the lens constantly to the same
direction may harm the internal rotation mechanism
and cause the lens' rotation harness to snap.
Tilting Range
Rotating Range
0° ~ 90°
0° ~ 360°