Manual

28
3.11 Dome Setup
CONFIGURATION MENU
HOME FUNCTION SETUP
VIEW ANGLE SETUP
ORIGIN OFFSET
FACTORY DEFAULT
DOME RESET
OSD DISPLAY
SYSTEM SETUP
FUNCTION RUN
SYSTEM INFORMATION
EXIT(ESC TO EXIT)
• HOME FUNCTION SETUP
HOME FUNCTION SETUP
FUNCTION : NONE
NUMBER : ---
WAITING TIME : 120 SEC
ENABLE : OFF
SAVE AND EXIT(ESC TO CANCEL)
FUNCTION NONE, TOUR, PATTERN, AUTO SCAN, PRESET
NUMBER ---
WAITING TIME 10 ~ 240 seconds
ENABLE ON, OFF
The Home Function can be set so that the camera automatically goes to Tour, Pattern, Auto Scan or
Preset.
For example, if the controller is idle for 120 seconds, the camera goes to Preset 1.
Follow these steps to program the Home position:
1. Select “FUNCTION” by pressing the Left or Right key to scroll through the None, Tour, Pattern, Auto
Scan or Preset functions.
2. Select “NUMBER” and press the Left or Right key. The recorded function number will scroll.
3. Select “WAITING TIME” and press the Left or Right key to select from 10 to 240 seconds.
4. Select “ENABLE” and turn to ON or OFF by pressing the Left or Right key.