Manual
Table Of Contents
- Table of Contents
- Chapter 1 — Introduction
- Chapter 2 — Installation and Configuration
- Chapter 3 — Program and Operation
- Appendix A — Dimensions
- Appendix B — Troubleshooting
21
3.6 Pattern
The Pattern feature records the user’s control of the camera. Up to 8 Patterns can be stored and played
back by pressing No. + PTRN keys subsequently.
PATTERN SETUP
(CTRL KEY)
NO TITLE SEC PERCENT
1 : P01 000 00.0%
2 : P02 000 00.0%
3 : P03 000 00.0%
4 : P04 000 00.0%
5 : P05 000 00.0%
6 : P06 000 00.0%
7 : P07 000 00.0%
8 : P08 000 00.0%
SAVE AND EXIT(ESC TO CANCEL)
Follow steps below to program the Pattern:
1. Press MENU to display the main menu on the monitor. Scroll to Pattern and press the Right key to enter
the Pattern menu.
2. Select the desired Pattern to be programmed by pressing the Up or Down key. If the Pattern is not 000,
a Pattern has already been recorded. Patterns can be overwritten.
3. Press the IRIS Open key then the “CONTROL” displays. Move the position and the zoom position. Press
the IRIS Close key then the “CONTROL” disappears.
4. To edit the “TITLE”, follow the procedure of the Auto Scan above to edit titles.
5. Select “SAVE AND EXIT” and press the Right key.
NOTE: If Pattern recording time reaches 500 seconds, it will automatically stop for a moment.