Manual

19
3.5 Tour
There are 8 programmable Tours. Each Tour consists of up to 40 Preset positions, Patterns, Scans or other
Tours (second-level). Using second-level Tours, it can be expanded to over 300 functions in a single Tour.
TOUR SETUP
NUMBER : 01
TITLE : T01
SCAN TYPE : NORMAL
SPEED : -- STEP
TOUR FUNC
SAVE AND EXIT(ESC TO CANCEL)
TOUR FUNC SETUP
(CTRL KEY)
DWELL : -- SEC
003 A04 --- --- ---
--- --- --- --- ---
--- --- P01 --- ---
--- T02 --- --- ---
--- --- --- --- ---
--- --- --- --- ---
--- --- --- --- ---
--- --- --- --- ---
EXIT(ESC TO EXIT)
--- Blank position
SCAN TYPE NORMAL, VECTOR
DWELL 03 ~ 99 seconds
003 Preset (1 ~ 240)
A04 Auto Scan (1 ~ 8, 10 ~ 17)
P01 Pattern (1 ~ 8)
T02 Tour (1 ~ 8)
Follow the steps below to program the Tours:
1. Press the MENU key to display the main menu on the monitor. Scroll to Tour and press the Right key to
enter the Tour menu.
2. Select “NUMBER” and set the desired number by pressing the Left or Right key.
3. Choose a blank position to be programmed by pressing the Up, Down, Right or Left key.
4. To add a Preset, press the Tele or Wide key then the stored Preset number displays.
5. To place functions other than Preset, press the IRIS Open key to scroll for Tour, Pattern or Auto Scan
respectively.
6. You can also overwrite the programmed number and remove a stored number from the Tour, press the
IRIS Open key until ‘---’ is displaying in the position.
7. Repeat step 2 through 6 for each desired position. Each title will be displayed on top of the line.