Manual

16
5. Select “MODE” and “SPEED”.
6. Select “START ANGLE”. Press the IRIS Open key to go to the “CONTROL” settings. Move the desired
position and the zoom position. Press the IRIS Close key then the “CONTROL” disappears. To adjust at
the 0.1 degree interval, press the Tele or Wide key at the pan field and the tilt field.
7. Select “END ANGLE”. Press the IRIS Open key to go to the “CONTROL” settings. Move the desired
position and the zoom position. Press the IRIS Close key then the “CONTROL” disappears. To adjust at
the 0.1 degree interval, press the Tele or Wide key at the pan field and the tilt field.
8. Set “SCAN DIR” to CCW or CW.
9. Select “SWAP”, Set to ON to exchange the start angle and the end angle.
10. Set “DWELL time”.
11. Set “FOCUS”.
12. Select “SAVE AND EXIT” and press the Right key.
NOTE: 09: AUTO-PAN mode (endless panning)