Manual

15
3.3 Auto Scan
The Auto Scan supports up to 17 programmed angles at different speeds. To setup an Auto Scan:
AUTO SCAN SETUP
NUMBER : 01
TITLE : A01
MODE : NORMAL
SPEED : 5 STEP
START ANGLE : ----- -----
END ANGLE : ----- -----
SCAN DIR : CCW
SWAP : OFF
DWELL : 03 SEC
FOCUS : AUTO
SAVE AND EXIT(ESC TO CANCEL)
NUMBER 01 ~ 08, 10 ~ 17, 09: AUTO-PAN mode.
TITLE up to 6 characters
MODE NORMAL, VECTOR, RANDOM (AUTO-PAN mode: NORMAL, RANDOM only).
NORMAL Move from start point to end point in panning only
VECTOR Move from start point to end point with tilt and zoom simultaneously and linearly.
RANDOM Move randomly between the start point and the end point
SPEED 1 ~ 13, the lower number the slower the camera will move.
SCAN DIR Set the Scan direction, CCW (Counter Clock Wise), CW (Clock Wise).
SWAP Swaps the start point for the end point.
DWELL Set the dwell time at both start and end points, 01 ~ 99 seconds.
FOCUS AUTO, MANUAL
1. Press MENU to display the main menu on the monitor. Scroll to Auto Scan and press the Right key.
2. Select “NUMBER” and set the desired number by pressing the Left or Right key.
3. Select “TITLE” and press the Tele or Wide key to enter the title edit mode.
4. Press Tele or Wide to change the alphanumeric characters. Move to the next position by pressing the
Left or Right key or move down to the character table and press the IRIS Open key at the desired
character. The cursor position will move to the next position automatically. Press the Left or Right key
at the “ALL DELETE” to delete all characters. Press Left or Right at the “EXIT” field to finish title edit menu.
TITLE EDIT MENU
(CTRL KEY)
A01
*
A B C D E F G H I J
K L M N O P Q R S T
U V W X Y Z 0 1 2 3
4 5 6 7 8 9 ( )
ALL DELETE
EXIT(ESC TO EXIT)