User Manual

Mounting Template
2
3
4
5
1
1
Using the mounting template sheet or the
camera itself, mark and drill the necessary holes
in the wall or ceiling.
2
Connect the network cable and power cable
respectively. See 'Installation - Cabling' for
details.
To use the camera’s waterproof wiring:
a. Install the LAN cable into (a) .
b. (b) will be assembled to (a) with a 1/4 turn.
c. Thread (c) tightly to (b).
NOTE: To ensure moisture seal, make sure the
o-ring is in place between (a) and (b). In extreme
environments use of an outdoor rated sealer is
recommended.
NOTE: When using the waterproof cap, crimp the
RJ45 connector after passing the cable through
the waterproof cap.
3
Use the two mounting screws to mount the
camera on the mounting surface.
Loosen the pan/tilt/rotate screws a little
before fixing the camera.
4
Adjusting the camera’s angle and view and
tighten the pan/tilt/rotate screws to lock the
camera’s position.
5
Remove the protective film from the camera’s
lens to complete the installation.
a
b
c
Installation -
Installation
8