User Manual

Maintenance
•
Maintenance:
o
Restart:
The unit is restarted without changing any of the settings. Use this
method if the unit is not behaving as expected.
o
Reset:
The unit is restarted and most current settings are reset to factory default
values. The settings that are not affected are:

the boot protocol (DHCP or static)

the static IP address

the default router

the subnet mask

the system time
o
Default:
The
default
button should be used with caution. Pressing this will
return all of the camera’s settings to the factory default values (including the IP
address).
•
Upgrade:
Upgrade your camera by importing an upgrade file and pressing the
Upgrade
butt
on. During the upgrade, do not turn off the power of the camera. Wait at least five
minutes and then try to access the camera again.
•
Backup:
Save the setting values that users have entered the camera to a user PC.
•
Restore:
Import and apply a setting value previously saved to a user PC.
•
IV License:
Upload your camera by importing an upload file and pressing the
Upload
butt
on. During the upload, do not turn off the power of the camera. Wait at least two
minutes and then try to access the camera again.
NOTE:
Backup and Restore can only be used on the same unit running the same firmware.
This feature is not intended for multi-configurations or firmware upgrades.
74