User Manual

Image Appearance:
This provides access to the advanced image settings for the camera.
•
Brightness:
The image’s brightness can be adjusted in the range 1 ~ 10, where a higher
value produces a brighter image.
•
Contrast:
Adjust the image’s contrast by raising or lowering the value in this field in
the range 1 ~ 10.
•
Saturation:
Set an appropriate value in the range of 1 ~ 10. Lower values mean less
color saturation.
•
Hue:
Set an appropriate value in the range of 1 ~ 10. The value distinguishes color, such
as red, yellow, green, or violet.
•
Sharpness:
Set the amount of sharpening applied to the image. A sharper image
might increase image noise, es
pecially in low light conditions. A lower setting reduces
image noise, but the image would be less sharp.
•
White Balance Mode:
Select white balance mode which fits camera installation
environment. In the case of Manual mode, the user can set R, G, B gain manually.
Enhance Control:
•
Enable wide dynamic range:
Activates WDR which cannot be used with Defog
function. If WDR is activated, shutter mode becomes automatic mode only.
•
Enable flip horizontal:
Check this box to flip the image.
•
Enable noise reduction:
Check this box to activate the noise reduction.
Once enabled, you can select the noise reduction level.
•
Enable defog:
Check this box to activate the defog function.
•
Metering Mode:
Users can change the metering mode.
This is a method of measuring the intensity of the light hitting and reflected by a subject
to determine the exposure required.
30