Manual

WEBVIEWER*
S e t up > N e t w o r k > O n V I F
O n V I F i s t h e O p e n N e t w o r k V i d e o I n t e r f a c e F o r u m .
1. To use OnVIF, check Enable.
2. Select the number of streams the camera will be sending using the OnVIF protocol. This may vary
depending on the software and server you use. Consult your NVR’s manual for additional
information. The camera will be set to dual stream on OnVIF by default.
3. Service Port will be set by default to “8032.” This is the camera’s OnVIF port. Use this port
information when connecting the camera to a server using the OnVIF protocol.
4. Select On or Off to Authenticate Address.
5. Select On or Off for WS-Discovery (Web Services Dynamic Discovery)
6. Select Apply to save changes.
40
[1]
[2]
[3]
[4]
[5]
[6]