User Manual
Table Of Contents
- Slide Number 1
- Slide Number 2
- Slide Number 3
- Slide Number 4
- Slide Number 5
- DIMENSIONS*
- INSIDE THE BOX *
- NETWORK CONNECTION*
- INSTALLATION*
- INSTALLATION*
- Slide Number 11
- Slide Number 12
- Slide Number 13
- Slide Number 14
- Slide Number 15
- Slide Number 16
- Slide Number 17
- Slide Number 18
- Slide Number 19
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- Slide Number 44
- Slide Number 45
- Slide Number 46
- Slide Number 47
- Slide Number 48
- Slide Number 49
- Slide Number 50
- Slide Number 51
- Slide Number 52
WEBVIEWER*
SETUP > BASIC CONFIGURATION > STREAM SETTINGS
Use this menu option to adjust the camera’s first and second streams.
The camera supports two simultaneous streams. The main stream is usually for recording and live
viewing with good bandwidth, and the secondary stream can be used for live viewing when the
bandwidth is limited.
• Max Bitrate: Set the max. bitrate to 32 ~ 16384 Kbps. The higher the value, the higher the video
quality. However, higher max bitrate will require higher bandwidth.
• Video Encoding: Select the type of compression to use when outputting the video. The compression
type affects the image quality, bandwidth, and file size of saved images. MJPEG, the lowest
Compression type, will provide the highest image quality, but also will cause the image size to be the
largest, and take up the most bandwidth. H.264 Baseline Profile is the default codec. The main
stream is set by default to H.264. The secondary stream can be set to either H.264 or MJPEG.
• I-Frame Interval: Set the I-Frame intervals from 1 ~ 400.
28