User Manual

WEBVIEWER*
SETUP > BASIC CONFIGURATION > NETWORK > TCP/IP
Use this menu option to setup the camera’s network settings.
Set the camera’s IP address, subnet mask, gateway and DNS server information. If applicable, you can
also setup the camera for multicast.
MAC Address: shows the camera’s mac address.
MTU: If applicable, you can enter the MTU setting value. The valid value range of MTU is 1280 ~
1500.
Multicast Address: If you are using the Multicast protocol, you can enter a separate multicast address.
The Multicast sends a stream to the multicast group address and allows multiple clients to acquire the
stream at the same time by requesting a copy from the multicast group address. Before utilizing this
function, make sure the Multicast function is enabled on your router.
Enable Multicast Discovery: Check the checkbox of Enable Multicast Discovery, and then the online
network camera can be automatically detected by client software via private multicast protocol in the
LAN.
DNS Server Enter a DNS address. The Domain Name Server translates a web addresses to an IP
addresses. You can enter up to two (2)
servers.
Once all settings are adjusted, save all
changes. The camera will reboot to
apply the new network settings.
25