User Manual
Table Of Contents
- Slide Number 1
- Slide Number 2
- Slide Number 3
- Slide Number 4
- Slide Number 5
- DIMENSIONS*
- INSIDE THE BOX *
- NETWORK CONNECTION*
- INSTALLATION*
- INSTALLATION*
- Slide Number 11
- Slide Number 12
- Slide Number 13
- Slide Number 14
- Slide Number 15
- Slide Number 16
- Slide Number 17
- Slide Number 18
- Slide Number 19
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- WEBVIEWER*
- Slide Number 44
- Slide Number 45
- Slide Number 46
- Slide Number 47
- Slide Number 48
- Slide Number 49
- Slide Number 50
- Slide Number 51
- Slide Number 52
WEBVIEWER*
SETUP > BASIC CONFIGURATION > NETWORK > TCP/IP
Use this menu option to setup the camera’s network settings.
Set the camera’s IP address, subnet mask, gateway and DNS server information. If applicable, you can
also setup the camera for multicast.
• NIC Type: Select the network card associated with the camera. The default value is Auto.
• DHCP: Check if you are using a DHCP network and wish for the camera to obtain all the network
settings automatically from the DHCP server. If this box is checked, the fields for the network settings
below will not be editable.
If you wish to enter the camera’s network settings manually, make sure the DHCP is unchecked and
enter the following information:
• IPv4 / IPv6: If necessary you can setup both IPv4 and IPv6 network settings
• IP Address – Enter an IP address for the camera
• Netmask – default is 255.255.255.0
• Gateway – This is your router’s external IP address. This address is used when accessing the camera
remotely from outside the network. The router will channel the data request to the appropriate port
associated with the camera.
24