User manual

5. When the dragonfly is fully charged, its eyes will stop pulsing, and turn off.
6. Carefully unplug the charging cord from the dragonfly, place
the cord back in the compartment of the controller and
then close the compartment door. Now you are ready to fly!
NOTE: When the dragonfly’s battery is running low, you will notice
his eyes will begin to dim and the sound of the motor on the
dragonfly will lower in tone and it will become less responsive.
Flying
When the dragonfly is fully charged and ready to fly, you can take your FlyTech
Dragonfly to the skies!
Location
You can operate FlyTech Dragonfly both indoors and
outdoors. The maximum recommended range for the
controller is 50 feet (15 meters).
For optimal indoor flying performance, we recommend a minimum area of 16 feet
x 16 feet (5 meters x 5 meters). For outdoor flying, try to avoid windy areas and
keep the dragonfly away from rain or other harsh conditions.
Flight modes
You can operate FlyTech Dragonfly in
one of two modes: Beginner or Expert.
To familiarize yourself with the controls,
start with Beginner mode. Beginner
mode allows for more gentle turns, and
Expert mode allows for sharper and faster
turns. Once you are comfortable with the
controls, you can switch to Expert mode.
To y the dragony
NOTE: Before you launch the dragonfly, make sure the rear rotor is not spinning
(otherwise it might not fly in the desired direction). If the rotor is spinning, adjust
the trim dial on the controller until it stops. The trim dial is the circular dial around
the power button on the controller.
To charge the dragonfly:
1. On the controller, push down on the magnetic perch. The cord compartment
door will open.
2. Pull the end of the cord from the compartment as shown.
3. Hold the dragonfly firmly by its body, and then insert the cord into the socket as
shown. Pay close attention to the orientation of the socket and the connector on
the cord.
NOTE: Make sure that the dragonfly is turned off before you recharge it.
IMPORTANT: Do not force the cord into the
socket – this can damage the socket. The
exposed silver contact points on the side of
the controller plug should line up with the
cut-away side of the socket.
NOTE: The controller is equipped with a sleep feature. The LED indicator will
turn off if the controller is idle for more than 1 minute. Therefore, when charging
FlyTech Dragonfly, the LED indicator light might turn off, however, the controller
will continue to charge the dragonfly. To turn the LED indicator light back on,
press the power button on the controller until the LED indicator lights up again.
4. Press the power button on the controller to turn it on.
If the connector on the cord is properly connected to the socket, the eyes on the
dragonfly will pulse slowly to indicate that it is charging.
Note that the eyes will blink rapidly if there is no signal from the controller.
When charging the dragonfly, make sure the cord from the controller is properly
connected to the socket on the dragonfly.
NOTE: You can rest the
dragonfly on the controller
while it is charging by placing
the metal perch point (on the
dragonfly) on the magnetic
perch (on the controller).
50 feet
(15 meters)
Expert modeBeginner mode
IMPORTANT: To prevent complete depletion of the FlyTech Dragonfly’s battery when not in use, ALWAYS
RECHARGE before storing. Severe depletion may result in permanent battery failure.