User Manual

3 VMAX IP Plus™ User Manual
1.2 System Startup
After connecting peripheral devices such as cameras, monitors and a mouse to the NVR, power up the NVR by connecting DC48V adaptor/ power cable to the
power jack on the rear panel. The boot logo will display. Please wait until the boot process completes.
To login, right-click anywhere on the screen and enter the username and password in the popup screen. There is only one Administrator Account configurable in the
NVR. It is assigned with an unchangeable User ID marked as ‘admin’. The default password is empty (No Password). Administrator account has full access to the
NVR and its configurable parameters and can also create new users and to assign rights to the new user accounts.
If NVR is set as AUTO LOGIN, login process is not necessary.
Caution
1) It may take a few minutes to startup the system after turning on the power, in case the user sets the network configuration as DHCP
mode but under the situation that there is no DHCP server in the network or the network is not connected.
2) The mouse is included. In case you need to replace it, it is highly recommended to choose well-known major brands such as DELL,
MICROSOFT, LOGITECH, or SAMSUNG.
Note
1) Do not forget the administrator’s password that was set for the first time. In case the password is forgot, contact your local dealer for help.
2) Refer to the “Section 4.1.2 User” for AUTO LOGIN and AUTO LOGOFF.
1.3 System Shutdown
To turn off the power, Click exit button [ ] the tool bar and then click [SHUTDOWN] in the pop-up screen as below. Do not pull off the power by pulling the
power plug.
Input the password and click [OK] to shut down the system. Click [YES] to confirm shutdown.