User Manual

User Manual | 48
RELAY
Select related output.
Caution
Relay contact can bear up to 24V 1A other devices. If it is connected to the power more than 24V 1A, the system may have problem with it.
DWELL
Set sensor operation time in between 1 and 15 seconds.
PRE-ALARM
Set recording period in seconds just before motion is detected. Input up to 5 seconds. The pre-alarm recording mode is always “continuous” at the recording speed that
user sets in the “Record” menu.
MOTION AREA
Set the camera’s motion area and sensitivity. The area can be selected by clicking on a specific block or dragging the mouse’s cursor across the screen to select
multiple blocks. Areas where motion detection is activated will appear with a green border line. Unselected areas will be shown with grey border.
Click [SET] in the ‘MOTION AREA’ section to set area.
Select the motion detection area and click [SAVE] () and then [EXIT] (③) to save the changes.
Clicking on SELECT ALL will enable motion detection in the entire camera’s FoV .
Note
Motion detection area and sensitivity should be set, properly, in consideration of the actual motion happened in the site.
COPY SETTING
To apply the settings to all cameras connected to the NVR, click on the Copy Settings button:
 Select the channel to get the setting from
 Select the property(s) to copy.
 Select the target channel(s) to apply the setting.
 Click [OK] to apply the setting to all the other selected channel(s).


