User Manual

User Manual | 42
4.2.3. PTZ
Full control of PTZ camera is available in this menu. Please refer to “3.6 PTZ Operation” for more information on operating a PTZ camera.
1. If the camera is connected to the NVR via ONVIF protocol, make sure ONVIF PTZ is selected in the Protocol field.
2. If the camera is connected via RS-485 cables, make sure of serial communication with the PTZ camera through RS-485 port are setup properly. The Protocol,
baudrate and cameras address set in the NVR must match the ones set in the camera’s settting.
PROTOCOL
Select the proper protocol of the connected PTZ camera. This field does not apply if the camera is connected to the NVR over the network via the OnVIF protocol.
BAUD RATE
Select the baud rate level from 2,400bps up to 57,600bps. This field does not apply if the camera is connected to the NVR over the network via the OnVIF protocol.
ADDRESS
Set the P/T/Z driver address of the connected camera. It should be the same as that of the PTZ. This field does not apply if the camera is connected to the NVR
over the network via the OnVIF protocol.
CONTROL(The functions depends on the camera’s model and supported features)
When the
[SET] button is clicked, the OSD menu of the camera will appear on the monitor. Set the PTZ’s speed, preset, tour, auto pan etc.
Direction buttons: move camera up/down & left/right.
M (depends on PTZ model): Show/ hide the camera’s OSD menu on the NVR monitor. Use the directional
arrows to navigate the menu options.
ZOOM/FOCUS/IRIS: Control IN (+)/OUT (-) for each functions. (Depending on camera’s model and supported
features).
Speed: Change the PTZ speed (0~100). This sets the speed in which the camera will move when controlled
from the NVR using the virtual joystick. Save the changes by clicking [SET].
Preset
 ADD: Move the camera’s position and zoom to the desired position. Select the preset








