User Manual

User Manual | 34
Upgrading system using USB memory stick:
1. Insert a USB drive with the firmware file formatted by FAT/FAT32 in any USB port of the NVR (compatible with USB 2.0).
2. Select ‘USB’ from the Method drop down options and press the ‘Scan’ button.
3. Once the system detects the USB drive, it will display the firmware file under ‘CURRENT VER’ and the ‘NEW VER’.
4. Click START to begin the upgrade process.
Upgrading system using Digital Watchdog’s Automatic Firmware Upgrade via FTP server:
1. Select FTP in the drop-down options under ‘Method’.
2. Enter the FTP’s address:
ftp.dwcc.tv and enter the username and password (these should be filled out automatically). Username:
vmaxipplus, password: vmaxipplus.
NOTE
The FTP server address is subject to change without a prior notice
3. Enter the Check Time. The system will automatically check the FTP server for a newer firmware every day at set hour.
4. Click [OK] button to proceed automatic firmware upgrade. After completed, the system will reboot.
5. Click ‘Check’ to allow the NVR to connect to the FTP server and check the latest Firmware version. If a new firmware is available, the NVR will
ask you whether you want to upgrade it or not.
6. Click ‘OK’ to confirm and click ‘START’ to start upgrading.
To setup the NVR to check for new firmware automatically:
1. Select FT from the METHOD drop-down options.
2. Make sure the ftp information is entered correctly (see section above).
3. Enter your convenient time at CHECK TIME and then click [SAVE] button.


