User Manual

23 | VMAX IP Plus™ NVR
PTZ Control
In PTZ mode, user can control PTZ camera using the USB mouse. While pressing the left button,
drag the mouse cursor up/down or left/rightward to move the camera’s pan/tilt position. The further
away from the center the mouse’s cursor moves, the faster the PTZ camera will move.
To move the camera to a preset position, click the preset position number in the bottom of the screen
to move the camera accordingly. The presets must be set prior to selection.
Note
Full PTZ functions are available by using the USB mouse, IR remote control, or keyboard controller. Availability of functions depends on the
camera’s ONVIF integration. Consult the camera’s manual for more information.
ZOOM/FOCUS
Move zoom-in/out by rolling the wheel of mouse up/down. If mode is changed to “Focus”, the camera’s focus can be controlled by
rolling the wheel of mouse.
PRESET
When the preset menu pops-up, select the preset number and click “Enter” to move to the corresponding preset position. Maximum
Preset number supported is 255.
TOUR
Enable the TOUR function. When ‘TOUR’ is on, the camera will move to preset positions in order. To turn the tour off, right-click on the
screen and select ‘Tour’.
GUARD TOUR
When enabled, the camera will automatically switch positions according to the sequence of presets set in the GUARD TOUR settings. See “4.2.3 PTZ” for more
information.
Caution
User can set interval for each preset position. Some presets might be skipped in case the camera cannot mechanically move or control focus
within the interval time.
GOTO HOME
Camera moves to the original position that is memorized in the PTZ device.
SETUP
Go to PTZ setup menu (Please refer to “4.2.3. PTZ”).
PTZ EXIT
Close PTZ control mode.