User Manual

19 | VMAX IP Plus™ NVR
 Select model to setup. All cameras with the same model name will be selected.
 Click [GET STREAM] button and get the current stream information.
 Click [Get INFO] button and check current setup for the cameras.
 Change setup and click [SAVE].
 “CAMERAS ARE SUCCESSFULLY APPLIED” message will appear when the process is completed.
3.4.3. Change channel
User can change channel by drag & drop from the live display screen.
Select a camera by clicking on it and dragging it to its new channel. During the dragging, the mouse pointer will
change to . In case of a PoE camera, channel title will be shown as in the example below.
In Live mode, user can check the status of PoE cameras by selecting [PoE STATUS] menu in the pop up menu
window.
3.5 Live Display Mode
3.5.1. Channel Selection
Live image can be seen by easy button operation after power-up. The images can be seen in 1, 4, 9 and 16 screen splits (some split options may not be available
according to the NVR’s number of channels). Whenever the up/down arrow button on the front panel or IR remote controller is pressed, and whenever the screen
display mode button ( ) on the tool bar is clicked, the screen will change to display the next channel or sequence of channels.
To switch from a multi-channel view to a single camera, click on the selected channel. To return to previous screen mode, click of the left mouse button again.
“VIDEO LOSS” is shown on the display screen when no camera is connected or disconnects suddenly. When a camera is disconnected, a warning sound shall be
generated depending on the system setting.
Admin users can set different level of authorization for each user, granting them specific access to specific channels. If a certain user is not authorized to view a
channel, no image is shown on the display screen as below.




Channel
No.
PoE Port
No.
Channel
Titl
e