User Manual

User Manual | 10
HDD FULL ()
Select “Overwrite” or “Stop recording” when HDD is full.
 Overwrite : NVR deletes oldest data and records new data.
 Stop recording : NVR stops recording.
HDD CHECK (
)
Click ( ) next to each HDD to view full information of each HDD such as model name, serial no,
capacity, bad sector ratio, life time (used time) and temperature.
HDD FORMAT (
)
Check the box next to the HDDs you wish to format and press the “FORMAT” button. If system resources are
occupied such as network connection during format process, the format process may fail. It is recommended
to reboot the system to release system resources and then try to format again.
Note
1) It may take a few minutes to format HDD.
2) When the format is done, all data in the HDD will be deleted.
3) The system always reserves some space in each built-in HDD to effectively utilize archiving memory.
2.4 Network
Setup the NVR’s network settings for remote connection.
NETWORK TYPE
Select either STATIC IP or DHCP for dynamic IP.
If DHCP is selected, the NVR will automatically configure the network settings according to the current network requirements. If DHCP is selected, click ‘IP DETECT’
button to detect automatically all the network settings.
If Static IP is selected, manually enter all necessary network settings. For proper configuration, it is recommended to assign the NVR a DHCP address and let it
auto discover all the proper network settings, and then change the Network Type back to Static IP and save the changes
IP ADDRESS