User Manual

Page | 37
PTZ preset (position) can be set for cameras in the event of Sensor activation. Preset feature on
PTZ camera can be activated by a sensor triggered. When Event occurs, PTZ moves to the
preset position.
PTZ camera activation can be set only for Sensor/Motion/Video Loss events. If there are multi
events occurring at the same time, it takes events in the following order: Sensor > Motion >
Video Loss.
2-6-2. MENU > EVENT > Motion
In Motion, setup Motion Detection, Sensitivity, View and Area options.
Camera: Check the box next to the camera to enable motion detection.
Sensitivity: Select motion sensitivity from very Low to Very High. (Default is normal).
Area: Define the area for motion detection in the camera’s Field of View. Press Setup under
Area to define motions detection areas.
The blocks indicate the area where motion detection is active.
Select Block: Using the USB mouse, click on the motion blocks you want to enable or disable.
Clear Block: Deselect all blocks inside a box.
Select All: Select all blocks on entire screen.
Clear All: Deselect blocks on entire screen.
View: View the appearance of motion zones on screen when motions is detected.
In Record, each camera can be connected to single or
multiple motion detections from other cameras. Press
to select cameras to be synchronized with motions
detections.
In Alarm, each camera with motion can be connected to
single and multiple alarms. Press to select alarms to
be connected to cameras for motion events.