User Manual

User’s Manual | 44
4.2.4 Motion Alarm
Select Motion alarm to record only when motion detection is triggered by DVR S/W upon user’s defined motion area.
An alarm signal is sent via the selected sensor-out channel.
 COPY SETTINGS
Upon pressing Copy Settings button, Copy Settings popup will appear. In this popup, choose the camera the
user wants to copy from at the “From” field. Choose the parameters such as Use, Notify, Relay, and Dwell Time
on the check box. Check on the checkbox next to the sensor numbers to apply the copy setting(s) to another
channel on the “To” box.
4.2.5 Extra Alarm
S.M.A.R.T. alarm is an alarm signal triggered when the HDD is about to be out of operation.
This alarm is created by the HDD and captured by DVR. If the HDD does not create this alarm, then the DVR also cannot
capture and output this signal.
Users also set the percentage for HDD Usage. For example, when Usage is 50%, DVR will notify by a camera popup or a
beep sound when HDD is 50% full.
NOTE
“Motion Alarm” here means alarm triggered by motion detection set by motion menu of DVR.