User Manual
Table Of Contents
- 1 Getting Started
- 1.1 Checking Supplied Items
- 1.2 Connecting Peripheral Device
- 1.3 System Startup and Shutdown
- 2 Explanation for Each Function
- 2.1 Front Panel
- 2.2 Rear Panel
- 2.3 IR Remote Controller
- 3 Operation
- 3.1 User Log-in
- 3.2 Quick Startup Wizard
- 3.3 Live Display Mode
- 3.4 PTZ Operation
- 3.5 Call Monitor Operation
- 3.6 Playback of Recorded Video
- 3.7 Quick Backup during Playback
- 3.8 Search Recording Image
- 3.9 DST Setting
- 3.10 Screen Saver
- 4 Setting
- 4.1 System
- 4.2 Device
- 4.3 Record
- 4.4 Network
- 4.5 Backup
- 4.6 Quick Setup
- 5 Web Client
- 5.1 Web Login
- 5.2 Web monitoring
- 5.3 Web Playback
- 5.4 Web Configuration
- 6 Pivot™ User Guide
- 6.1 PC Requirements
- 6.2 Software Installation
- 6.3 Software removal
- 6.4 Basic Operations
- 6.5 Pivot Functions
- 6.6 Pivot Setup
- 7 MAC ACS User Guide
- 7.1 System Requirement
- 7.2 Install
- 7.3 Basic Operation
- 8 Mobile Phone Software User Guide
- 8.1 iPhone application software
- 8.2 Android application software
- 9 Appendix : Network Setup for External Usage
- 10 Appendix : Specification
User’s Manual | 22
User can automatically switch PTZ camera positions according to defined presets by using the GUARD TOUR function. The
connected PTZ camera must support touring functions. “GUARD TOUR” on the pop-up menu can be enabled only in full
screen mode. See 4.2.6 PTZ for instructions on how to setup the GUARD TOUR.
3.5 Call Monitor Operation
Using your mouse, right-click on the screen and select the CALL MONITOR in order to enter call monitor control mode. The
numeric panel will pop up at the center of the screen. Click the specific channel to display in full screen mode out of the
channels assigned to the spot out monitor.
▪ Press the close button at the bottom of the panel to return to the previously programmed spot monitor mode.
N
OTE
- A spot monitor displays another spot out monitor’s video in full screen through the function, call monitor.
- In spot sequence setting mode, if Call monitor is selected, spot sequence stops and selected channel
pops up.
- While call monitor runs, if a channel event happens, Call monitor stops and the event pops up.
C
AUTION
Depending on the PTZ camera, some preset positions might be skipped if, for example, the PTZ
camera cannot mechanically move or control focus within the interval time required by the DVR. In
this case, it is recommended to increase the interval setting to a value that allows for the cameras to
finish its Pan & Tilt.