User Manual

38
opposite way.
Note
Check the setting of the sensor type (N/O or N/C). It is recommended to use “Dry Contact Type”
while “Wet Contact Type” may cause the damage to the system.
NOTIFY
Select how to be alerted when the sensor is activated or motion is triggered by
pressing “NOTIFY” button. The system will generate buzzer sound in the selection
of buzzer and/or make pop-up screen of the camera in the selection of camera
pop-up.
Note
“Camera pop-up” means that multi-screen live video mode will be switched to single channel mode
automatically upon alarm triggered. This single channel video is the channel triggered by alarm.
4.3.2. MOTION ALARM
Motion alarm enables the system to begin recording when motion is detected by the cameras. The system
will trigger an alarm signal via the selected sensor-out channel.
ON/OFF
Turn the sensor on or off.
CAM
Select the associated camera.
OUT
Select the associated alarm output.
Caution
Relay contact can stand up to 24V/1A. If it is connected to the external circuit which is over
24V/1A, the system may experience problems.
INTENSIVE(RECORDING)
When the alarm is triggered, the DVR is switched from recording mode to continuous mode during the
selected dwell time. (Please refer to the “4.4.1 CAMERA” for detail.)
DWELL (Post Alarm)
Set the sensor operation time to between 1 and 15 seconds. During this period, the corresponding camera
will record according to the Record setting. The recording stops and alarm output is turned off when the set
period is elapsed.
