User Manual

User Manual | 18
full screen mode. To activate PTZ control, right-clicking and selecting PTZ in the pop-up menu.
When in PTZ mode, will appear on the right-button corner of the screen.
 PTZ Control: In PTZ mode, user can control PTZ
camera using the USB mouse. While pressing the
left button, drag the mouse cursor up/down or
left/rightward to move the camera’s pan/tilt
position. The further away from the center the
mouse’s cursor moves, the faster the PTZ camera
will move.
To move the camera to a preset position, click the
preset position number in the bottom of the screen
to move the camera accordingly. The presets must be set prior to selection.
NOTE
Full PTZ functions are available by using the USB mouse, IR remote control, or
keyboard controller. Availability of functions depends on the camera. Consult the
camera’s manual for more information.
 Zoom / focus: Move zoom-in / out by rolling the wheel of mouse
up/down. If mode is changed to “Focus”, the camera’s focus can be
controlled by rolling the wheel of mouse.
 Preset: When the preset menu pops-up, select the preset number
and click “Enter” to move to the corresponding preset position.
Maximum Preset number supported is 255.
 Guard tour: When enabled, the camera will automatically switch
positions according to the sequence of presets set in the GUARD
TOUR settings. See section 4.2.3 PTZ for more information.
CAUTION
User can set interval for each preset position. Some
presets might be skipped in case the camera cannot
mechanically move or control focus within the interval
time.
 Control: Go to PTZ control menu. See section 4.2.3. PTZ.
 PTZ exit: Close PTZ control mode.
3.4 Playback Recorded Images
To playback recorded image, press the Play button on the IR remote controller or playback icon