User Manual

41 | VMAX A1 Plus™ DVR
 Click SET in the MOTION AREA section to set area.
 Select the motion detection area and click SAVE and then EXIT to save the changes.
 Clicking on SELECT ALL will enable motion detection in the entire camera’s FoV.
NOTE
Motion detection area and sensitivity should be set, properly, in consideration of the
actual motion happened in the site.
 Notify: Enable motion notification via a buzzer sound and/or a pop-up warning.
 Copy setting: To apply the settings to all cameras connected to the DVR, click on the
Copy Settings button:
 Select the channel to get the setting from
 Select the property(s) to copy.
 Select the target channel(s) to apply the setting.
 Click OK to apply the setting to all the other selected channel(s).
4.3.3. Extra Alarm
Setup alarms for additional DVR abnormalities such as smart HDD check, video loss, recording
failure and disk full.
 S.M.A.R.T.: Trigger an alarm signal when HDD is about to be out of operation. Please
refer to “4.1.4 HDD” to check the HDD status.
 Video loss: Trigger an alarm signal when a camera signal is disconnected.


