User Manual

User Manual | 34

4.2.3. PTZ

Full control of PTZ camera is available in this menu. Please refer to section 3.3 PTZ Operation

for more information on operating a PTZ camera.

 Protocol: Select the proper protocol of the connected PTZ camera. If PTZ camera is

connected by UTC type protocol, baud rate and address setup is disabled.

 Baud rate: Select the baud rate level from 2,400bps up to 57,600bps. (Not supported in

UTC type protocol).

 Address: Set the PTZ driver address of the connected camera. It should be the same as

that of the PTZ. (Not supported in UTC type protocol).

 Control (The functions depends on the camera’s model and supported features): When

the

PROGRAM button is selected, the OSD menu of the camera will appear on the

monitor. Set the PTZ’s speed, preset, tour, auto pan etc.

a. Direction buttons: move camera up, down, left

and right.

b. M (depends on PTZ model): Show/ hide the

camera’s OSD menu on the DVR monitor. Use

the directional arrows to navigate the menu

options.

c. Zoom, focus and iris: Control IN (+) and OUT (-)

for each functions. (Depending on camera’s

model and supported features).

d. Speed: Change the PTZ speed (0~100). This sets

the speed in which the camera will move when

controlled from the DVR using the virtual joystick. Save the changes by clicking

SET.

e. Preset

 Add: Move the camera’s position and zoom to the desired position. Select

the preset number using the button. Press ADD to save the new preset.

(The system supports preset the number of preset from 1 to 255.)

 Delete: delete the preset currently selected.

 Move: Enter a present number and press Move to move the camera to the

preset position of that number.