User Manual
User Manual | 28
b. Make sure the ftp information is entered correctly (see section above).
c. Enter your convenient time at CHECK TIME and then click SAVE.
• Video signal: Check the right video signal (NTSC or PAL). This setting should match the
NTSC/PAL selection switch located on the rear panel. Video images might heavily shake
and blink if NTSC/PAL is not properly set.
• IP address: Shows the DVR’s current IP address. It can be set at MENU > NETWORK >
NETWORK.
• Auto IP: Shows the DVR’s IP address.
• MAC address: Shows the unique identity number for the DVR.
• System monitor: Monitor the system performance and condition.
• Keypad beep: User can turn on or off the beeping sound of key pad.