User Manual
Table Of Contents
- Cautions
- Read Before System Operation
- Signs of Caution and Warning
- General Warning
- Cautions about the Power
- 1. Getting Started
- 2. Startup Wizard
- 3. Operation
- 4. Setting
- 5. Web Surveillance through Internet Explorer
- 6. Q & A
- 7. Specifications
User Manual | 40
• Dwell (post alarm): Set the recoding period from when the sensor is activated. During
this period, the selected camera will record according to the record setting. The
recording stops and alarm output is turned off when the set period is completed.
• Pre-alarm: Set recording period in seconds just before a sensor is activated. Input up to 5
seconds. The pre-alarm recording mode is always continuous at the recording speed set
in the RECORD menu.
• Type: Select the sensor type as N/O (Normal Open) or N/C (Normal Close). The circuit
of an N/O sensor type is usually open, and the activation of the sensor occurs at the
time of close, and N/C type works the reverse way.
• Notify: Enable sensor notification via a buzzer sound and/or a pop-up warning.
NOTE
When “camera pop-up” is enabled, in a multi-screen mode, the system will switch to
single channel mode automatically when the alarm is triggered.
4.3.2. Motion Alarm
Setup the DVR to start recording when motion is detected. The system can also trigger an alarm
signal via the selected sensor-out channel.
• On, off: Turn on or turn off the motion
• Relay: Select related output.
CAUTION
Relay contact can bear up to 24V 1A other devices. If it is connected to the power
more than 24V 1A, the system may have problem with it.
• Dwell: Set sensor operation time in between 1 and 15 seconds.
• Pre-alarm: Set recording period in seconds just before motion is detected. Input up to 5
seconds. The pre-alarm recording mode is always “continuous” at the recording speed
that user sets in the “Record” menu.
• Motion area: Set the camera’s motion area and sensitivity. The area can be selected by
clicking on a specific block or dragging the mouse’s cursor across the screen to select
multiple blocks. Areas where motion detection is activated will appear with a green
border line. Unselected areas will be shown with grey border.
NOTE
Check the setting of the sensor type (N/O or N/C). It is recommended to use “dry
contact type” while “wet contact type” may cause damage to the system.