User Manual
    User Manual | 28 
b.  Make sure the ftp information is entered correctly (see section above).   
c.  Enter your convenient time at CHECK TIME and then click SAVE. 
  Video signal: Check the right video signal (NTSC or PAL). This setting should match the 
NTSC/PAL selection switch located on the rear panel. Video images might heavily shake 
and blink if NTSC/PAL is not properly set. 
  IP address: Shows the DVR’s current IP address. It can be set at MENU > NETWORK > 
NETWORK. 
  Auto IP: Shows the DVR’s IP address. 
  MAC address: Shows the unique identity number for the DVR. 
  System monitor: Monitor the system performance and condition.   
  Keypad beep: User can turn on or off the beeping sound of key pad. 










