User Manual
Table Of Contents
- Working with DW Spectrum
- Opening and Closing DW Spectrum Client
- Connecting to DW Spectrum via Web-Client
- Launching DW Spectrum in Compatibility Mode
- Connecting to Enterprise Controller and Working Offline
- Introducing User Roles
- DW Spectrum User Interface Overview
- DW Spectrum Quick Start
- Obtaining and Activating DW Spectrum Licenses
- Obtaining and Configuring Media Server’s Additional Settings (Admin Only)
- Cameras and Encoders Management
- Viewing Full Camera List
- Adding Cameras and Encoders
- Setting Up Cameras
- Setting up Analog Cameras
- Renaming Cameras
- Obtaining Camera’s IP, MAC, Firmware and Model
- Configuring Audio on Camera
- Configuring Camera's Authentication
- Setting up PTZ
- Setting Up Fish-Eye Cameras
- Setting up Recording Schedule
- Setting up Motion Mask and Motion Sensitivity
- Configuring Proprietary Camera Parameters
- Adjusting Secondary Stream Quality
- Setting Same Parameters for Multiple Cameras
- Swapping Cameras between Media Servers (Admin Only)
- Diagnosing Offline Cameras
- Deleting Cameras (Admin Only)
- Configuring Events and Actions (Admin Only)
- Tracked Events
- Setting up Schedule for Tracking Events
- Motion on Camera
- Camera Disconnection/Malfunction
- Storage Failure
- Network Issue
- Camera IP Conflict
- Input Signal on Camera
- Media Server Failure
- Media Servers Conflict
- EC Connection Lost
- Licenses are not Configured
- E-mail is not Set for Users
- E-Mail Server is not Configured
- Error while Sending E-Mail
- Storages are not Configured
- Actions that DW Spectrum Can Do
- Default Rules
- Viewing Events Log
- Tracked Events
- User Management
- Layout Management
- Creating New Layout
- Setting up Layouts
- Assigning Layouts to Users (Admin Only)
- Deleting Layouts (Admin Only)
- Opening and Closing Saved Layouts
- Backing up and Restoring DW Spectrum Database
- Playback in DW Spectrum
- Screen Recording (Windows Only)
- Upgrading DW Spectrum
- Troubleshooting and Contacting Support
- Glossary
64
DW Spectrum User Manual
Digital Watchdog
3. Set the desired parameters and click Apply.
If needed, a user can add a camera to the selection by holding the Ctrl button and clicking on the
desired camera in Resource Tree.
To set up another camera(s), select the desired camera in Resource Tree. It is not necessary to close
the settings dialog.
If the changes are not applied, the following warning message will appear:
4. When finished, press OK to apply or Cancel to discard settings.