User Manual

DW Spectrum 3.0
Rev. 072017 Page | 95
2. Check the cameras to record, then click OK (Cancel will discard changes).
To select all Cameras on a specific Server, check the corresponding box. To filter search, use the Filter box. Filter
criteria is the same as search (see "Search"). It is possible to Drag'n'Drop the selected Cameras from Resource Tree
onto the Action's advanced settings form.
IMPORTANT. To record Camera on Event, recording must be enabled on Camera. Refer to "Modifying
Recording Schedule" for information on how to enable recording. If the "Recording" flag is not set on the selected
Camera, the following message will be displayed (see above).
Advanced Parameters
Quality and fps – target recording parameters for Camera(s). If Camera's maximum FPS is lower than specified,
maximum FPS will be acquired.
Post-recording – the time it takes for the recording to be performed after the event is f complete.
May be caused by
Motion on Camera
Input Signal on Device
Generic Event.