User Manual

DW Spectrum 3.0
Rev. 072017 Page | 45
First, Make sure Subnet Scan is unchecked, then enter RTSP or HTTP URL (i.e. rtsp://<camera
IP>:554/hi_stream) instead of Camera IP.
Once added, Camera will be displayed in Resource Tree as follows:
It can now be configured as any regular IP Camera (see "Setting Up Devices").
Note: only one stream can be added per Camera, so Dual-Streaming benefits will not be available (see "Dual
Stream Recording Specifics (RADASS)"). Lastly, if resolution is greater than 720*576, software motion detection will
not be available.
Setting Up Devices
It is possible to configure Devices for Administrators and Viewers that have the appropriate access Permission.
Administrators can configure all cameras and Viewers can only use the ones that are assigned to them by
Administrators.
A user can locate Device Settings from Device's Context Menu that can be invoked from Resource Tree or From Scene
The following actions can be performed when configuring Device Parameters:
 Setting Up I/O Modules
 Renaming Devices
 Obtaining Device’s IP, MAC, Firmware and Model
 Configuring Audio on Device
 Configuring Device's Authentication
 Forcing Aspect Ratio for Cameras
 Setting up Camera Orientation
 Setting up PTZ on PTZ and Fish-Eye Cameras
 Setting Up Fish-Eye Cameras
 Setting up Recording Schedule
 Setting up Motion Mask and Motion Sensitivity