User guide

96
7K, 9K series
12.3 CONFIGURING THE DVR
To enable the Emergency Agent on the DVR follow these steps:
1 Enter SETUP and confirm you are in the CAMERA SETUP
menu.
2 Select a camera and then associate sensor(s) to that camera
using the SENSOR CONNECTION checkboxes.
3 Click the Communication Setup button and make sure that
DISABLE REMOTE CONNECTIONS is not checked in the
Communication Setting menu.
4 The Emergency Agent uses one port to transfer the data
through. The port can be adjusted inside the Communication
Setting Menu if necessary . It is recommended that unless the
port must be changed, that the default setting should be used.
5 Enter the IP Address of the computer running the Emergency
agent software in the Emergency IP in the Network Setup
section.
6 Click OK.
7 Select the Sensor & Control menu tab.
8 Enable the Sensor you wish to use.
9 Adjust the record, delay, output, and duration settings. (See
the Sensor & Control section in the Setup Option Chapter for
descriptions of these functions).
10 Click OK.