User Manual
POWER AND CONTROL CONNECTIONS
REMOTE SWITCHING
The Illuminator may be activated remotely
by a volt-free contact latched across the
telemetry wires (see Diagram above).
PHOTOCELL FOLLOWING CONTACT
Volt-free relay contact-normally open (day)
to normally closed (night). See Diagram
above.
RECOMMENDED PSU
A PoE switch or injector is recommended.
The power supply should be used with
devices to protect against short circuits and
overload.
Mounting
bracket
Reset
Shows
LED
Pressure
relief valve
IM Ethernet
cable with
IP68 connector
OUTPUT +
OUTPUT -
TELEMETRY +
TELEMETRY -
CABLING THE ILLUMINATOR
Connect to PoE+ switch or PoE+ injector
for power and network connection.
The illuminators are powered by Power
over the Ethernet (PoE+) via a network
cable connector to a PoE IEEE802at
compliant switch. The power consumption
of the illuminators complies with PoE+
IEEE802at.
The illuminators are not supplied with
a power cord. They are supplied with a
3.28ft (1m) long network cable. At the
end of the network cable is a female RJ45
Cat5e compliant jack with an IP68 rated
cover.
To use the illuminator’s waterproof wiring:
a. Install the LAN cable into .
b. will be assembled to with a 1/4
turn.
c. Thread tightly to .
Power requirements Power consumption
PoE+ (IEEE802.3at) 26W
a
b
c
a
a
b
b
c
NOTE: To ensure moisture seal, make sure the o-ring
is in place between and . In extreme
environments use of an outdoor rated sealer is
recommended.
a
b
NOTE: When using the waterproof cap, crimp the
RJ45 connector after passing the cable
through the waterproof cap.
NOTE: Ensure that the IP68-rated cover is correctly
fitted and attached to the network cable. If
this is not fitted correctly, moisture can get
into the connector and may cause the unit to
malfunction. This would void the warranty on
the product.
NOTE: Illuminator will flash once every second when
insucient power is applied.
7