User Manual

9 | Compressor™ Onvif Encoder
2. Installation
Mount and install any external devices such as cameras, sensors and microphones according to the installation
instructions. Connect the external devices to the encoder’s rear based on the diagram above. Below is an example
of a proper connection between the Compressor, the cameras, and your remote monitoring software.
Figure 2-1 Connection map
2.1 Connecting exterior devices
How to connect external devices to the ports in the back of the device:
1
Place the unit in a stable flat surface.
2
Do NOT install the device too close to the wall. Protrusive connectors in the rear of the unit may be forcedly
curved or pressed, which can cause fires, electric shocks, or injury.
3
When connecting external devices to the encoder, make sure the system is off and the power cable is discon-
nected.
4
Connect analog cameras to the video in ports in the back of the encoder. The encoder will detect the camera’s
signal automatically upon connection.
5
Connect a microphone to the audio input ports and a speaker to the audio output port. Be sure to check
regulations in the area whether recording to be legal or not.
6
Connect a monitor to the VGA, HDMI or CVBS port.