Quick Start Guide

Quick Start Guide
3. Click X on upper left corner of the Time and Date window when done.
* Closing the window will automatically save the changes made.
STEP 3: Configure Network
Please have the following information ready before starting the network configuration.
Camera Network
Local Network (LAN)
IP Address
Subnet Mask /
Netmask
Default Gateway /
Gateway
Not Applicable
DNS Servers
Not Applicable
* Camera Network and Local Network cannot be on the same network.
Windows
1. Double click Network Connections on the Desktop
2. Right click on the Ethernet with cable connected and click Properties.
NOTE If you are not sure what information to enter, contact your Network Administrator or Internet Service Provider
for the information.
NOTE The Blackjack Cube’s network settings are set to DHCP as default.
3. Click X on upper left corner of the Time and Date window when done.
* Closing the window will automatically save the changes made.
STEP 3: Configure Network
Please have the following information ready before starting the network configuration.
Camera Network
Local Network (LAN)
IP Address
Subnet Mask /
Netmask
Default Gateway /
Gateway
Not Applicable
DNS Servers
Not Applicable
* Camera Network and Local Network cannot be on the same network.
Windows
1. Double click Network Connections on the Desktop
2. Right click on the Ethernet with cable connected and click Properties.
NOTE If you are not sure what information to enter, contact your Network Administrator or Internet Service Provider
for the information.
NOTE The Blackjack Cube’s network settings are set to DHCP as default.
3. Click X on upper left corner of the Time and Date window when done.
* Closing the window will automatically save the changes made.
5
Linux
1. Update Date and Time by clicking on the time on the upper right-hand corner then click “Time & Date settings…”
2. If the server will be connected to the Internet, leave Set the Time to “Automatically from the Internet” and update the Location to
the correct Time Zone. Enter the nearest major city to select the correct Time Zone. If it shows multiple cities in the list, select the
correct city. (e.g., New York for EST, Chicago for CST, Denver for MST, and Los Angeles for PST)
Press OK after adjusting to the correct date and/or time.
4. Press OK to close Date and Time when done.
Linux
1. Update Date and Time by clicking on the time on the upper right-hand corner then click “Time & Date settings…”
2. If the server will be connected to the Internet, leave Set the Time to “Automatically from the Internet” and update the Location to the correct
Time Zone. Enter the nearest major city to select the correct Time Zone. If it shows multiple cities in the list, select the correct city. (e.g.,
New York for EST, Chicago for CST, Denver for MST, and Los Angeles for PST)