User Manual

User manual

2. Setup

2.1. Setting up the Blackjack

NAS

STEP 1: Connecting the network cable.

1. Connect the network cable to the network port . and a network switch.

STEP 2: Connecting the power cable

1. Connect the power cable to the DC power port . The Blackjack

NAS will turn on.

2. The front power LED will indicate whether the Blackjack

NAS is on.

STEP 3: Configure the network settings

On a computer in the same network as your Blackjack

NAS unit:

1. Go to: http://www.digital-watchdog.com

2. Search for ‘IP Finder’ on the quick search bar at the top of the page.

3. The latest IP Finder software will appear in the search results. Click on the link to download the

file to your computer.

4. The software will scan your network for all supported cameras and display the results in the

table. Allow up to 5 seconds for the IP Finder to find the camera on the network.

5. Find “Blackjack NAS” on the devices list, click on the “Click” button in the column of “IP Conf.”

6. Enter the network information, username and password.

7. Click on the “Apply” button.

NOTE Initial network information

• Network type: Static

• IP Address: 192.168.1.200

• Netmask: 255.255.255.0

• Gateway : 192.168.1.1

NOTE It is recommended to use Gigabit switch for a stable storage performance.