User`s manual

96 • Vacon apfiff09 marine
Tel. +358
6
P2.2.11.3 Motor potentiometer reference copy ID366
This parameter defines how reference is handled when reference input is changed to
motor potentiometer in I/O control.
0 No copy
Reference is not copied. Depending on function, the drive may start
from minimum frequency or from reference that was last used when the drive was
run with motor potentiometer.
1 Reference
The drive active reference is copied. If the drive is ramping when the value of motor
potentiometer is changed the drive will continue ramping after the change.
This allows the reference copy in stop state unless the
overruns it (e.g. reset in stop state is not selected).
2
Speed at the time of change is copied to reference. If the drive is ramping when the
change is made the drive will stop ramping and keep the present speed.