User`s manual

242 • Vacon apfiff09 marine
Tel. +358
6
B04: FALSE = Coast Stop Activated, TRUE = Coast Stop Not Activated
Coast Stop Activated: "Coast Stop (OFF 2)" command is present.
Coast Stop Not Activated: Coast stop command is not active.
B05: FALSE = Quick Stop Activated, TRUE = Quick Stop Not Activated
Quick Stop Activated: " Quick Stop (OFF 3)" command is present.
Quick Stop Not Activated: Quick stop command is not active.
B06: FALSE = Switching On Not Inhibit, TRUE = Switching On Inhibited
Switching On Not Inhibit:
Switching On Inhibited: The drive goes only again in the "Switched On" condition with "No Coast
Stop AND No Quick Stop" followed by "ON". This means that the "Switching On Inhibited" bit is only
set back to zero if the OFF command is set after "No Coast Stop AND No Quick Stop".
B07: FALSE = No Warning, TRUE = Warning Present
No Warning: There is no warning or the warning has disappeared again.
Warning Present: Drive still works; warning in the service/maintenance parameter;
no acknowledgement.
B08: FALSE = Speed Error Out Of Tolerance Range, TRUE = Speed Error Within Tolerance Range
Speed Error Out Of Tolerance Range:
Speed Error Within Tolerance Range:
B09: FALSE = No Control Requested, TRUE = Control Requested
No Control Requested: Control by the automation system is not possible, only possible
at the device or by another interface.
Control Requested: The automation system is requested to assume control.
B10: FALSE = f Or n Not Reached, TRUE = f Or n Reached Or Exceeded
f Or n Not Reached: Speed is below P2.6.4.5 Above Speed Limit.
f Or n Reached Or Exceeded: Speed is above P2.6.4.5 Above Speed Limit.
B15: FALSE = FB DW Feedback Low, TRUE = FB DW Feedback High
FB DW Feedback: FB Control Word B11 is echoed back to the Fieldbus. Can be use to monitor
communication status from the drive.