User`s manual

218 • Vacon apfiff09 marine
Tel. +358
6
7.14.4 Free DIN Delay
This function is mend to be used on situation when certain DIN signal needs On or Off delay
before actual command is given. e.g. Reading from DIN Status Word: DIN1 status giving it a
e.g. 1,00 s delay and then writing it by ID number to ID403 Start 1, thus giving 1 second delay to
start in drive side.
P2.14.7.1 ID.Bit Free Digital input delay ID1832 DIN
Select digital input from DIN Status Word to be delayed.
P2.14.7.2 On Delay ID1833 On Delay
This defines ON delay for the input signal.
P2.14.7.3 Off Delay ID1834 Off Delay
This defines OFF delay for the input signal.
P2.14.7.4 Mono Time ID1836 Mono Time
This timer makes a pulse that last defined time. Pulse will start after On Delay time.
P2.14.7.5 Control Out ID ID1835 Control Out ID
Select the signal ID to be controlled by input signal. If inversion or parameter value other than
zero and one is needed this can be connected to DIN ID Control function ID1570, ID1590 or
1578 where desired values can be set and connected to correct parameter.